Initial C daemon

it works... not optimized... at least it compiles...

uno-stats-monitor/unomond/unomond.conf

@@ -0,0 +1,38 @@
+// Daemon config
+delay = 10000; // in ms (1 second = 1000 ms) - do not set too low or the systat calls will return junk
+tty = "/dev/ttyACM0"; // tty device to use (most common for arduino based boards on *nix)
+logfile = ""; // logfile - leave undefined for console output (syslog is always used if possible for hard errors)
+line_length = 16; // unused but will be needed
+line_count = 2; // unused but will be needed
+
+// readings
+cpu_temp_file = "/sys/class/hwmon/hwmon1/temp11_input"; // doesnt have to be cpu, any temperature reading in C will do
+cpu_fanspeed_file = "/sys/class/hwmon/hwmon1/temp11_input";
+
+// drives (free space stats)
+// dev note: for a 16 line display, 3 drives will barely fit depending on the GB available so choose wisely
+drive_free_space = [ "/", "/mnt/local", "/mnt/store" ] // list of mountpoints - NOT devices!
+
+// IR command config
+// TODO: lookup xf86 and/or dbus commands for multimedia control
+ircmd_P = "echo Power Pressed"; // P power
+ircmd_M = ""; // mute
+ircmd_m = ""; // mode
+ircmd_p = ""; //  back
+ircmd_f = ""; //  forward
+ircmd_e = ""; //  eq
+ircmd_minus = ""; //  vol down
+ircmd_plus = ""; //  vol up
+ircmd_r = ""; //  return
+ircmd_u = ""; //  usb scan
+ircmd_0 = ""; //  number 1
+ircmd_2 = ""; //  number 2
+ircmd_3 = ""; //  number 3
+ircmd_4 = ""; //  number 4
+ircmd_5 = ""; //  number 5
+ircmd_6 = ""; //  number 6
+ircmd_7 = ""; //  number 7
+ircmd_8 = ""; //  number 8
+ircmd_9 = ""; //  number 9
+ircmd_R = ""; //  repeat
+ircmd_Z = "echo Unknown Pressed"; //  other button pressed